A good owl light with switch, a perfect gift for someone.
Make sure to have a heatsink on LED.
Use a heavy base and screw owl base to it.
The screws to use are M3 self trap, you can also use m3 machined screw with a square nut.
Made for 200mm tall owl
LED i use is 5W AC220V (70ºc max). 10W would go up +/-150ºc with the heatshink i use, so i advice to test temperature before serious use this.
After finish the LED placement and solder, switch it on, you will able to see the left and right side screw holes, drill a 3mm hole on that position to screw the owl wood to the base.
Photo Album: https://www.facebook.com/pg/PTRTECH/photos/?tab=album&album_id=362912154192964
No bottom layer nor infill for owl print only 2 or 3 perimeters.
I print into ABS, so 5mm brim would help.
Other models are pretty standart
Choose from normal base with borders or slim version without the borders and screw the center directly with long screws.
Print cable holder is optional but heavy recommended, so if anyone push the cable the force will be applied to holder and not the owl base or solder.
Use a high temperature material or else it will melt with strong leds!