Parametric Herringbone Differential for OpenRC F1 car.
This is a remix of the great differential design by tahustvedt:
It should fit the original OpenRC F1 car design by barspin:
It uses the gear library created by janssen86
I have printed the differential in ABS and did use nails (1.6 mm) as axles (instead of 1.75 mm filament as done by tahustvedt).
- SpurGear.stl (1x)
- PinionGear.stl (1x)
- SmallGear.stl (5x)
- BigGear.stl (1x)
- BigGearRimSide.stl (1x)
Instead of the standard PionionGear.stl, one could also use either of the following pinion gear types:
- PinionGearFlatAxle.stl (better fits the axle of the motor)
- PinionGearNutHole.stl (this requires a m3 nut and a small m3 screw, see photo)