Blackcoin Raspberry Pi 3 (Two Piece) Case https://blackcoin.co
No nuts and bolts required, the ras pi board slides into the Board Tray and the Sleeve slides over the Board Tray (A tab clips into place to prevent the two pieces moving apart).
The underside of the Board Tray has two slots 1" (25mm) apart for sliding the assembled box onto two wall mounting screws.
The two pieces have been designed with a slight tolerance to allow them to slide together and apart without too much effort.
The two parts when first used will be a tight fit and should therefore be assembled and separated several times WITHOUT A RASPBERRY PI BOARD inside to loosen them, and then only insert the board once you are happy you can easily separate the two sections without damaging the board.
The Box is a work in progress so use at your own risk, the vented sleeve is recommended for 24/7 staking but be aware it has not been tested to see if the board overheats with prolonged use (Regular monitoring of your board temperature is a must).
Blackcoin High Five Donation Address:
No Donation necessary, just a high five / well done type of thing :)
Check Out A Blackcoin Private Key Gift Coin: https://www.thingiverse.com/thing:2751071
>>>Files now include two types of desk stand that fit into the screw mount slots, and a wall mount for use with double sided tape or nails (for times that you don't want to mount straight to screws in a wall)<<<
Print orientation depends on whether you mind removing large amounts of support material post print and if your supports leave scarring. I print the sleeve with blackcoin logo on the top (Sleeve full of supports) and the board tray with the sd slot facing the bed (minimal supports).