These are the LEFT and RIGHT supports to be used on a DELTA/Kossel 3d printer. the supports are designed for an HeatedBed of 220mm diameter and a glass of 240mm diameter. (Both of them of 3mm thickness) The supports can be printed in PLA (ABS is not necessary, tested for a lot of hours @100°C with PLA)
These supports uses the original stock screws given with the original supports in the kit of the Anycubic DeltaPlus.
Obviously these supports can also be used with other Delta printers.
To center the bed, preplace the supports at about 90mm eachother on the same side.
Keep in mind that these supports are lowered respect to the glass, in this way the head can fly over them and so can be used all the area!
Anycubic Delta Plus Linear
Place the supports on the bed on a side so that:
- for the LEFT the "8" must be near the bed
-for the RIGHT the "E" must be near the bed
In this way the supports are not required.