Fits Prusa MK 2.5 or MK 3 with the *V2 type cable attachment that has BOLTED TERMINALS.
This bracket changes the orientation of the heatbed cable 90 deg clockwise to allow the printer to fit in a IKEA cabinet. It reduces the rear dimension by about 50mm and has plenty of cable slack.
You will need to bend the cable terminals with a pair of pliers so they are angled at 90 deg as per the picture. They are pretty durable and this is needed so the bolt hole is not obstructed and there is no interference with the LED or resistor that are surface mounted to the heatbed.
I cut off and re-terminated one of the terminals so there was no excess cable when re-orientated to the right.
You will need Qty 3, M3x10mm machine screws and Qty 3 M3 nuts to complete this modification.
The top bracket has been replace with V2 to reduce the overall height (-2.5mm) to give more clearance for the heat block heater cables.
Please verify that all print head cables clear the bracket before first print.
Use PETG or ABS.
I did 3 perimeters in PETG and it seemed pretty strong