For use with the stock bed clips.
I had to scale up the print to fit in one of the clips installed on the Mini Delta because the pin was too loose. The other two clips worked good and had a tight fit without the need for scaling.
I have not yet tested these pins with this Thing
If you prefer the stock molded plastic part you can purchase them at GigDigit.com
I had to use a desk fan blowing on the printed part while printing else the layers would not be smooth.
Printed with eSUN 1.75mm Red PLA PRO (PLA+) @ 90 mm/s
Printed on the MP Mini Delta with the following temperatures. (Probably not needed to start as high but it works for me.)