Cable Clip to clip together the Bowden tube and cable bundle to the CR10S hotend. Should fit onto CR10 too. Multiply to as many as you want, I have 5 or 6 on my CR10S4. They actually snap in place quite satisfyingly and don't pinch the Bowden or the cables.
Printed these because I had to change my Bowden tube and did't want to tape it back up as it looked rubbish. Didn't want to use tie wraps either as you have to replace every time. These are reusable, and remarkably durable. I have been using them for two months, many hours of printing, and have changed the Bowden a few times. None have broken yet!
If you want to keep your CR10 in good shape then try our Silicone oil for the rollers
and PTFE grease for Z axis screws
We are a UK based company that specialises in affordable automation solutions
Despite the chamfers, stuck well to glass bed
May need initial layer height is set at 0.3 to get enough squish. Printed on their sides in PLA bed temp 60