Reduce to the max : Micro-Whoov
Having built/printed a dozen different versions I now present my latest version - the Micro-Whoov.
It consists of 1 printed part, the top. The skirt is 1 single strip of foam glued below the top.
Alternatively one can print the skirt and glue below.
Dimensions are 11cm x 9.5cm - weight ready-to-run is 37 grams.
Inductrix_whoov_V3.1.stl is for the original Inductrix (not FPV)
E010_whoov_V2.stl is for the Eachine E010
Skirt_high_V2 is a printed shirt instead of the foam strip
Inductrix Tip: swap front/back connectors (plug left front into left back plug, right front into right back) - so it does not spin like mad but goes straight. The E010 does not need that.
This was printed in PETG, PLA will also work fine
Glue the top motors on the holder (I used double-sided tape).
Inductrix: 2 M3 screws to hold the FC (holes are threaded). Battery plugs in from the back
E010: Use original screws to mount the FC. Battery plugs in from the bottom
The skirt is one strip piece of foam. I had some 6mm EPP lying around, most anything will do.
Glue it to the bottom, I used contact glue. Alternatively, use the printed skirt
Designed in Fusion360