My Giant Lego figure lamp!
It's 48.5cm talls. About 12 times the size of an original Lego figure. This is a redesign/blow-up of the Blank Minifig, Jumbo Snap-Together Version design by Skimbal.
- made the head hollow to fit a lamp (e14 fitting)
- modified the chest to be firmer and fit a lamp
- added wedges for firmer stand
- added tube to the hips for wiring
I only added the modified files. The original files can be found in the originial project by Skimbal. Just print them 3x larges as provided.
Notes on the chest:
Only after my print I modified the chest for what I think should a) offer a better fit to the hips and b) added - for your convenience - a hole for the fitting. I had to make this space afterwards, which looks a bit messy if you take of the head. The modified chest doesn't have a hole for the wire. You can easily drill this hole in afterwards. I think if you add a hole to the design, you should print with support. Without the hole you can print without support and save some time and material.
Notes on the wedges:
Also I added two wedges to put in the hips after the legs are attached. This will make the figure stand a bit more firm.
For the head & hips I did use 3% zigzag support. The other parts are printed without support.
The infill I used was 40% with two 'gradual infill steps'. Meaning most of the figure has a 10% infill moving up to 20% and 40% just below the surface.