Organize your cables and wires by using cable combs. This customizable thing can produce both open (clip on) and closed combs in all kinds of sizes. You may change a lot of features to fit your needs.
This thing uses a few levels of value verification to ensure the values you put in are feasible. Remember that printers can be crude and require more material to create a solid part. I recommend adding a bit of rigidity through the "Strength" value and increase the "Wire diameter" beyond your measured diameter due to the (often) small print moves which most likely fall off a bit short.
v1.5 - 2019-02-09
IS_CLIP_ON=1 with negative
HORIZONTAL_SEPARATION now span across the whole part
v1.4 - 2018-12-08
TYPE="demo" introduced to demonstrate all other types
- Each type is now separated into it's own module
SIZE is now automatically calculated based on
v1.3 - 2018-12-05
TYPE="slim" with extreme
VERTICAL_SEPARATION produced separated meshes
- Assertion added for
IS_CLIP_ON=1 with more than 2 rows
IS_CLIP_ON=1 now has a single open side rather than two
- Assertion warnings may now be switched off using
- Wires can now be spaced apart using
TYPE="cut-away" introduced which can be cut to size after printing
I recommend not using a brim if your printer can handle it. It will be a pain to cleanup.