This is a cable chain adapter for the lower part of the bed wires. I´ve designed this because I want a clear look to my printer.
This was made to be used with this part, but you can use the way you want. It has a hole to route Y axis motor and limit sensor wires. I´ve designed this to be smaller as it can, so maybe you need to disassemble the motor connector to route it and then reassemble. It´s quite simple.
It´s for 10x20 mm chain.
It should be printed the way it´s in the file for resistance. It was not designed with a specific resolution in mind, just printed with 0.3 mm layer and 30% infill and it did great.
I’ve replaced the bed wiring with silicon wires for better flexibility. Would recomend. Added a picture of the printer finished with the mods.
Depending on the material, supports may be difficult to remove. I´m having good experience with support using ABS. PETG is a little bit more difficult, and PLA is a pain with support.
Used clear PETG in this one. It´s not as beautiful as ABS, but will work.