V2 uploaded, added ridges on the power and volume buttons for more finger feels. Increased the size of the power button for increased clicky click and increased the camera cutout corner radii for maximum smoothness.
I've always wanted a slim case which also shows the back dBrand sticker for my Galaxy S7 but could never find one. This case started out as a challenge for me to design a tight fitting case but grew to something much more frustrating, this is the result after many revisions.
The case is extremely thin, an average of just 0.66mm thickness from a model I've made of my S7. There is a small lip around the screen which allows the phone to lie screen down without the home button or screen touching the surface below.
I suggest printing this with a nozzle of 0.3mm with a line thickness of 0.33mm or with a 0.2mm nozzle with a 0.22mm line thickness and using supports up to about 2mm.
There are two versions, one has a headphone jack hole which should be able to fit most small/medium sized plugs and the other does not have the hole. I suggest printing the on without if you're only using bluetooth headphones because the hole is quite big and could potentially compromise the rigidity.
After printing you'll propably have to seperate the volume and power buttons from the case a little to make them click better.
I've printed mine at 0.2mm and 0.1mm layer heights. Make sure to have supports under the buttons from build platform or they'll probably fail.