Remix of Redcat's original Everest 7 inner fenders: https://www.thingiverse.com/thing:2584736
but more compatible with the the SPORT model (rather than the PRO):
REAR:When I printed and attached the original rear fenders, the 8 holes were bumped-out away from the frame. Fine for the Gen7 PRO model, but on the Gen7 SPORT the holes did not align properly, so I changed the holes to be flush with the frame, eliminating the gap between the 8 screw holes and the frame. There is also no roll cage on the SPORT model, so I removed the groove along the top of the fender for the roll cage pivot bar.
FRONT: cut-out a section at the front of the fender to prevent wheel-bite on the leading edge while turning or while shocks are fully compressed.
I redesigned both of these parts using Autodesk Meshmixer