This is part is designed to allow me to push my monitor a bit farther back on my desk. This part is sized for an old Ikea desk but is customizable and should work for any desk that has no back and a roughly circular edge profile.
It's small enough to fit in the MPSM's 12x12x12 build volume with a bit of careful positioning.
The thin/flat edge goes above the desk, with the monitor resting on it, with the lower area for support.
Monoprice Select Mini v2 (MPSM v2)
Should be printed with 4x0.4mm thick walls resulting in large thin area at the top being 100% solid for strength.
This used just over 100g of PLA, but I've been using this for over a month with zero visible sag.