I finally came around and made the XL version available, happy printing!
This is currently made to hold the Stinger Quad Torch Lighter by Vertigo which is available over at Dynavap's website: https://www.dynavap.com/dynashop/accessories/quad-torch-lighter
The lighter's dimensions from the site show: 8.2cm x 3.5cm x 1.9cm
To fit, I measured with some calipers and made the lighter hole this size:
X,Y,Z (X)40mm x (Y)20mm x (Z)88mm
***Important, if you want your Dynavap to center in the magnet like the OG Dynastash, you will need to purchase a DIAMETRICALLY aligned magnet for the middle. If you do not specifically look for this you might end up with a magnet that is AXIALLY aligned by mistake and the Dynavap will not stick in the middle of your disc magnet. Trust me, I know this, I made this mistake.
***You can also just order the magnet provided by Dynavap in their website, but as I designed this with a thicker magnet disc, the one from Dynavap will look pushed in, I might design another case so that it looks almost flush and works with the magnet from Dynavap.
Disc Magnets needed:
2x Neodymium Magnets 1/4 x 1/16 (6mm x 1.5mm)
1x Diametric Neodymium Magnet 1/2 x 1/8 (13mm x 3mm)
Since I made this with the intention of printing in PLA/Wood Filament. The Lid may be a loose fit when printing in other materials such as just PLA.