This mount is the simplest thing I could come up with to add angle to the camera on the QX95 for the TX02 camera.
The mount is held in place by the rubber bands that hold the camera in place, which makes it easy to replace when you want to change angles.
No tape is required, and because the mount has no parts to hold the camera it should be compatible with all AiO cameras around this size.
Available in 5, 10, 12.5, 15, 17.5, 20, 25 degrees
I printed these at 0.2 and the angles seemed to come out fairly accurately. Based on the small number of layers a smaller layer height will produce a better result.
Flipping the print upside down so the smooth side (from the bed) is up, can provide a better surface to put the camera on.