I wanted to put the CR-10 control box on a riser - the hot-end cables became too short after some modifications.
After designing the legs, rather than have a big empty space underneath, I integrated some drawers which have been very handy so far.
(no mirroring required)
4x M3x12mm Cap Screws
8x 625 RS Bearings (5mmx16mmx5)
Consider printing the rails at 100% infill.
I printed the shelves vertically - I needed to reduce XY Jerk to 2 to ensure no layer shifts. Feel free to try printing them flat.
- Snap Bearings onto the rails
- Slide the four rails into the leg pieces, connecting them.
- Fit the legs so that they line up with where the old feet were and screw them in.
I cut and glued some rubber squares to the feet for traction. I would recommend doing something similar so that the control box isn't sliding around.
- Use Super Glue to affix the two front drawer caps to the drawers
In an earlier version of this design, one that didn't use bearings, I added aluminum foil tape to the shelf flanges to help with friction.
I'm not sure it's still needed in the new design, but it looks kinda cool so I left it on.