This is my personal radio stand tuned for Turnigy 9x and Taranis.
some time ago I own a metal radio stand for an old Futaba radio, so I decided to reverse engineering and refit for my radios.
This design will fit radios wit 4 and 5 mm diameter handle, simply with a small adjust of the hole. The fixing hole itself ha a tight fitting so slipping is adjusted by the torque of the four M3x12 hex type screws.
I added two STL for the stand, one with my personal logo and one without logo.The two spacers are the same.
I printed mine with ABS at 100% infill so the strenght is ok and it's possible to torque the screws without cracks. PLA should work good but pay attention to the nuts seats because I tuned the dimension considering ABS shrinkage.
You need four M3x12 mm screws toghether with forur nuts M3.