These are designed to work with 1 inch on center pegboards.
- Hooks: Three sizes
- Pliers holder: prints upside down, lip helps reduce wiggle
- Caliper holder: should fit any standard caliper, includes space to keep two LR44 batteries
- Screwdriver holder: Three hole sizes (13mm, 7mm and 5.5mm diameters), slots in the front to slide in magnets (8mm diameter, 3mm thick) (0.3 in. x 0.11 in). Sand the 4 clip in parts a bit if you have a hard time pushing it into the pegboard.
PLA or ABS
At least three shells
The caliper holder has built in supports and the rest don't need support