This is my remix of Super Halloween Lantern Tea Light by magicstick. I used meshmixer to separate the image of the panel to print without changing the filament in mid-print.
Top, Bottom and Handle are scaled up a little bit.
I added the corner to remplace the black line in the side panel
I scaled some Halloween Magnet by Misterdid to fit on panel
I used black PLA and transparent orange PLA
I print all 0.3mm layer hight and 0.4 layer width 15% infill
I glued all the pieces together but the handle for acces to the thea light
Print in 0.4 or less line width or the Cat will not print correctly