Thank you to ThatSlacker for coming up with the original design.
Remix of this https://www.thingiverse.com/thing:2034547
I run KDE Direct 2206 2050Kv motors on my FT SuperBee and the mount this guy had designed would be epic, aside from the back my motors need a hole behind them to fit the collar for the motor shaft.
I Went with only a 3Degree tilt like his setup, and beefed up everything. Thick walls, 3 Covered post guides, and set it up to fit with Carbon rod instead of the normal stuff.
The nice bit is they hold up to the 2.5lb of thrust my motors output on 6s 22.2v.
My only warning is they are a Pain and a half to attach, because the rod mounts have to be moved close to the wing surface to prevent tearing. And the rods also make it hard to screw the motor on.
I had supports only for the center of the bearing hole, and the 3 rod guides. It was printed with ABS using an enclosure to add strength, mainly because it needed to hold up to a few pounds of pulling force coming from the motor.