End mounts now available and added, for Geeetech prusa I3 pro (C) .
For my dual extruder printer the chain on thingiverse wasn't heigh enough for all of my cables. (also some mods made ti the printer :) ).
I also found that the lower round edge would not come out looking good without some support.
And the movement between the links was quite rough.
I've redesigned these links for an addition 5mm space in height (width is the same!).
And the rounded edge is now a 45 degree angle, no support required.
And it is still compatible with the original ;)
Also trimmed 0.05mm in width from the inner sides to give a much smoother motion!.
Now you don't have any issues while printing!.
Enjoy ! ;) now you can put all your cables in.
Derivate from the cable Chain by Modelstation
what you wish, mine was at 0.3mm