Micromake C1 COREXZ
These are all the parts you need to convert your Micromake C1 to the COREXZ system. This conversion eliminates the racking motion of the X-axis inherent to the H-Bot system.
As a result you will get true circles and not elliptical circles :) Top and bottom layers will also be nicely closed, no more annoying space between the filament lines. Please note that the effector is designed for a MGN9H linear rail (310mm).
Make sure you read the firmware notes below before doing this conversion, there are some cables you need to switch!
This firmware is intended for the Micromake C1 COREXZ conversion. It will
not work correctly with a stock Micromake C1!
For this firmware to work correctly with your converted Micromake C1,
please switch the X and Z stepper motor cables on your main board. The
original X motor plug needs to go into the Z motor socket. Subsequently
the orgininal Z motor plug needs to go into the X motor socket.
This firmware uses 64 step resolution. You need to switch your main board
resolution by removing the MS-1 jumper from the main board. The included
image shows you where to find the MS-1 jumper.
After the above steps, upload this firmware to your board and you are done.
Some parts come out nicer if you use some supports, the upper effector and hotend clamp for instance.