Pictured is an iPhone 6 with an Otterbox Symmetry case. This stand should work with all the later iPhones as well. It may or may not fit a "Plus" sized phone depending on what case you have. The “Adapter Piece” pictured has a trough cut out to accommodate my thick case, but I included two other configurations and you can also design your own from the dimensions provided. This stand will work for both the plastic and steel watch chargers. If you use the steel charger, there is a shim piece you can print (since the steel charger is thinner).
The parts you need to print are Stand Base, Left Side, Right Side, Adapter Piece, Watch Charger Cap, and Clip (x2). The Stand Base has recesses for ½” self-adhesive feet (there is also a version without them). The feet I used are like this:
The Right Side and Left Sides I printed with an extra layer added to the bottom, which I sanded off afterwards. That seems to give you the best looking seam when you put them together and it helps reduce warping. If you use the “base layer” STL file, set your first layer thickness equal to the base layer thickness.
You may have to adjust the dimensions of the two clips so that they pull the left and right sides together fully. The 8.5mm configuration worked well for me.
There is a PDF with assembly instructions (slightly outdated) included in the download files.
Please give this design a like and upload a pic of how it came out!
Silver ESUN PLA+ @ 210 nozzle/60 bed
1mm shell (or 2x nozzle diam)
Support needed for Base (if using version with feet recesses) and Left/Right sides
Brim recommended for all parts