A remix of my MK9 Blower mount with servo probe to accept a BL Touch.
The BL Touch is centered in front of the nozzle (X Axis) and ~37 mm forward (Y Axis) - this allows the BL Touch to not impact glass clips etc during large prints that take up the whole bed.
Note: you may need to increase / decrease the Z position of the BL Touch to get clearance/adjust the Z Axis offset. (my offset is -0.70 mm, YMMV).
The blower nozzle can be found from Hydroslide here:
The fan/blower can purchased from here:
Don't want a fan - use the mount without the fan brackets
Print with ABS or PETG to avoid warping from nozzle heat