Something to decorate your desk :)
Dome: PolySmooth™ Transparent
Printer: Mass Portal Pharaoh ED15 (0.6 nozzle)
0.2 layer height
0.75 extrusion width
210˚C / 60˚C
40mm/s printing speed (with cooling overwriting)
(Lower the jerk and acceleration of your printer if its a commun cartesian printer :) )
I poor alcohol inside to the top (like a cup) for 3-5min, I then polished the outside faces with the Polysher for 3*10min (5min drying with a fan).
As for the base I used the same printer, PolyWood™ profile with over extrusion, sand it down slightly with a file then use a lighter to even out everything.
The succulent is not from me but I dont find the link anymore so I post the stl i downloaded :(
It was smth like this : https://www.thingiverse.com/thing:2314536
Hope that help :)
I used the Polysher to polish the transparent cover and the succulent.