Wanhao Duplicator 7 VAT Standard and XL.
Standard design is a rip off from the official VAT.
Enhanced version is reworked as: Slopped edge, pouring slope, increased capacity.
- 330ml - Standard.
- 350ml - Standard Enhanced.
- 400ml - XL.
- 420ml - XL Enhanced.
Bear in mind, XL version is 1cm taller than the standard version. It does fit in v1.4 but I can't be sure for other. Use at your own risk.
You will need the following hardware:
- 22x M4x12x8 Metal spacer (12mm length, 7mm width face to face).
- 22x M4x10 Countersunk screws.
//Specific link removed due to unconsistant reference.
// The total cost is around 16$ (100 pcs of each) enough to make 4 VAT.
Double check the standoff you get and modify the STL according to yours if the stock hole (exactly 7.2mm face to face) is incorrect.
This is not litterally a remix but since mister Z use big word and think he own the design right on FlexVAT or any VAT that exist, here it is.
This is NOT from his design but to please him, I'll act like it is. =)
The original model posted here is under license CC BY-NC 3.0 which allow me to:
Share — copy and redistribute the material in any medium or format
Adapt — remix, transform, and build upon the material
And "The licensor cannot revoke these freedoms as long as you follow the license terms."
Attribution — You must give appropriate credit, provide a link to the license, and indicate if changes were made. You may do so in any reasonable manner, but not in any way that suggests the licensor endorses you or your use.
NonCommercial — You may not use the material for commercial purposes.
According to https://creativecommons.org/licenses/by-nc/3.0/
The model is made by "ZioFester" on Thingiverse, it has been adapted and redistributed here has it without any warranty. The model is released free of charge for everyone.
Print 1 version of your liking and 1 seal.
The metal spacer is tight fit but use glue/epoxy then push them in place.