This is a Holder + Case for a 5inch LCD Screen with HDMI and USB touchscreen.
It should fit very snugly on to the frame of the Orginal Prusa i3.
Please read the Post-Printing section before you start printing !
After using a 3,5 inch TFT Screen with this Holder i made :
it was time for something bigger...
Also check out the tutorial on Github how to Setup Octo print on a RaspberryPie with jessie :
( https://github.com/foosel/OctoPrint/wiki/Setup-on-a-Raspberry-Pi-running-Raspbian ).
If you have any questions please do not hesitate to ask me.
Don't forget to tell me about your prints in the Comments and leave a picture of your setup.
It always makes me very happy to see your results.
Happy Printing ! :D
Try to print the Parts like on the Screenshot of Slic3r above.
I used Hobbyking PTG filament to print the parts.
PLA would probably also work fine but I recomend using "stronger" filament (ABS, PETG, ...)
After you have printed the bottom and top part of the case and 2x Holder-Arms it's time to put everything together.
You will need:
- 4x M3 Screws
- 4x M3 Nuts
- Some type of glue (I recommend Epoxy or Superglue)
- Glue the two Holder-Arms ONLY to the top part of the case like in the picture below.
- Screw the top and bottom part together using M3 Screws and Nuts.
I used @yoyojacky "5 Inch LCD HDMI Touch Screen Enclosure" and modified only the top part of the case since I couldn't import the bottom part STL file into Fusion 360 without errors.
I only modified it to fit the Holder arms and left everything else like it was so check out his design and leave him some credit :)