This is a 80mm Fan Mount for the Anet A8 Power Supply (base 50mm x 110mm), to prevent it from burning.
If you want to have any modification, like a cablemanagement, or other fan sizes you can do it by yourself (.stp and .scad included), or just leave a comment, i'll see what i can do.
What you need
- 4x M3x18 or M3x20
- 4x M3 nut
- 1x M3x6 or M3x8 (optional to screw it down to the power supply, but it also sits strong
without a screw)
PS: The screw-hole on the back has been set to the correct position (Not how it is in my picture).
I added a version with a round fan hole. That can be printed witout any support (thanks to https://www.thingiverse.com/LordCarvalho for profing it).
All Walls in this part have a thickness of 1.6mm, so i would print it with this wall size, bottom- and top-layer thickness. Than you won't need to care about infill. The support should be round about 8% and must be everywhere, not only touching buildplate!
Printingtime on my A8 with 50mm/s and 0,2mm layer heigh 05:57.
The "Power Supply Fan Mount Anet A8 - round" could be printed without support (not tested).
The position of the screw-hole on the back has been corrected.