rigid prusa x ends with lm8uu bearings
its the x-end and the x-motor-end.
for the x-motor-end:
both are with m4 nut-traps for holding the smood rod in place.
Also changed the depth of the nut traps, they weren't deep enough to fit the actual nut while the rods were in place ...
And the holes weren't big enough to fit the lm8uu so i changed that to make'm fit!
and for the x-end:
I redesigned the motor end to give it the same "look"..
Either one normal and one mirrored version to make a set, depending on what side you want your motor on.