This is a simple, utilitarian remix of the CR-10 Steampunk legs. Instead of highly decorative legs, these are simple rectangles turned at an angle to give a large amount of surface/support area for the leg. Printed on CR-10 at .3 layer height, 3 wall thickness and 30% infill for strength. At 130 mm tall (5.12 inches) it should just allow the control box to slide under the without wasting too much cable length to the printer.
Remixed in Tinkercad, you can edit the design here: https://www.tinkercad.com/things/8MqjCUV80rT
This design prints 2 legs at a time, of course you will need a total of 4 legs for the printer. As with the original these use the existing connectors and simply replace the rubber feet & plastic plate of the CR-10.