This is an Iphone 6, 6s & 7 compatible case.
Similar to my other Iphone case this one has bumpers but the are Hearts instead of lines. If you use ABS or PETG it will be strong enough to leave in the car in the summer & not melt. I also updated the camera hole to be a little more snug, let me know what you guys think in the comments!
I have had it on my phone now for 3-4 weeks and it has held up great and it has been dropped several times & survived unscathed.
I printed it with PETG (For the heat & Strength properties) at 0.1mm Layer height with supports for the bumpers. If you wanted it a little stronger you could print it @ 0.2mm layer height but you might lose some detail.
Happy Printing everyone!
This thing was made with Tinkercad.
Best to printed not in PLA for the heat properties, I recommend PETG or ABS.
I would light sand the back & sides just to make it smoother to the touch. If you print it in ABS use a vapor bath to smooth it down just a little. This would help also with any layer adhesions problems if some come up over time.