Made to hold the charge cable for my Tesla EV. I've printed it but I have yet to test it. The sliding mechanism to hide the screws is very thight but if you have a dimmensionally correct printer it will fit.
There might be design changes to the part that the screws goes into as the angled side on the top is on the wrong side and it also makes it a bit though to print due to overhang at the start.
I only used support for the slot for the screw/fixing mechanism. there is a lot of overhang on the top of it so if you don't have very good cooling I'd suggest to put some support there also. I printed it without support up there and have some rough surface in that area so will be testing a print with some support at the top.