This is not an easy print!
You should know your printer very well.
This print is built like a model kit!
Basic assembly skills are necessary.
So, this is the MARK V tank from Battlefield 1.
Everything is based on the ingame model...from which I could not use a single part :(
So I had to model everything from scratch. But I´m more than happy with the result :)
I have added a sliced version for people with smaller printbeds (like me).
Dimensions are: 16 x 7,5 x 5,5 cm
I know that the paint job is not 100% accurate to the game but I like it that way. Show me that you can do better ;)
Have fun printing!
& don´t forget to check the instructions below ;)
Most parts need NO support!
Filename says _support if you need it!
If you are using the non sliced Version, skip Step 0.1
Yes, I know, gluing sliced version 1.1 - 4.2 is a pain in the a**.
Lay the parts down on a flat surface and use as less glue as possible. Secure them with a piece of tape while the glue dries.