This is a basic mount for the BL Touch to be attached to the original E3D clamp made by Tech2C (clamp provided).
The mount is a simple design to just bolt onto the "fan" mount of the clamp. The fan mounts aren't used in the case of the hypercube as it uses a blower fan packed behind the hotend rather than next to the hotend.
Just use a few M3 nuts and bolts to hold the mount to the clamp and then again with the clamp to the main X carrage mount. Use a few M3 nuts and bolts to hold the bltouch in a fixed position.
Theres a small cutout on the part to pass the cables through from the bltouch to the top of the mount to allow you to plug them in.
Basic part to print flat on the bed, no need for any fancy settings.