I really liked the dream catcher earrings created by OnePunchMan however did not have any feathers to attach so I decided to print some. I used the feather earrings by Vivenda, but as I needed to shrink them down so small, there was not enough filament on the end to fit a jump ring through. I used Tinkercad to add a larger cylinder. I printed more feathers than I needed incase I broke one or two.
The dreamcatcher is printed in wood PLA filament and the feathers are in Bronze PLA. All printed at 0.1mm resolution and infill of 100%. I heated a sewing needle (held by pliers) using a lighter and pierced it through the end of the feathers to fit the jump ring though easier.
Slow the print right down to avoid stringy bits. I've found that wood and bronze PLA are less stringy at a lower temperature.