I wanted to build a wolfstock style delta-bot, using Makerslide linear slides. But, I wanted to run the belt through the inside of the Makerslide for a cleaner look.
This is still very much a work in progress, I'm currently working on completing the design and building the printer.
I'm posting a build log on my blog:
-added belt clip, bolt to back of makerslide carriage
-added belt tensioner to idler bracket
-added tensioner arm
-Added carriage mount for rod ends
-Added platform (intended for budaschnozzle but lots of mounting holes for anything)
-added rod sleeve (for reinforcing end of carbon rods)
-updated platform and rod carriage mount to improve fit with traxxas rod ends
-updated platform and rod carriage mounts to allow better clamping of traxxas rod ends including variability in rod end center width
-added shroud for 40mm fan
-added bowden tube mount for Budaschnozzle
-added 5mm spacer for Budaschnozzle
-added platform for magnetic bearings
-added carriage mount for magnetic bearings
-added M5 threaded rod end caps for magnetic bearings
-added upper and lower braces to stiffen structure.
-added new versions of the platform and sliders to give more clearance to tie rod ends
-added improved fan shrouds, two versions
-designed RAMPS mount to neatly attach RAMPs and Arduino to bottom of platform. I added this as a new thing: http://www.thingiverse.com/thing:1997781
-added improved fan shroud
-added mount for 12mm diameter inductive or capacity proximity sensor for auto-bed leveling