This is a remix of the Anet A8 Fan Duct Spaceship edition by paul0. I really liked his design, but I couldn't use it because of my auto leveling sensor. I remixed it with a holder for an 18mm located directly in line with the extruder nozzle using SolidWorks 2017. Sadly, I broke it removing it from the bed. The painter's tape held REALLY well, so there is no post processing pic. Also, I'm having to make something else since I just purchased the RepRap.me Diamond Hotend. The offsets for firmware are X10.0 Y-64.0. I hope anyone who prints this enjoys it.
I tweaked it to fix some of the issues with it so it will fit without having to do any sanding/drilling etc if your machine is in good calibration. The firmware offsets for this new version are X4.0 Y-70. I hope this one works better for everyone like it does for me.
I use MatterHackers MatterControl 1.6 using the Cura slicer engine. I printed at 20.0mm/s for it come out like it did.