After a trip to the hobby show to get some supplies and some parts I realized when I got home that the spot for glue was getting a bit crowded. Not to worry, this machine on my desk should relieve some crowding with a custom shelf. This was no doubt a very quick drawn shelf but quick and efficient is one of the many draws to 3D printing for me. So down and dirty quick fast in a hurry I measured out all of the glue containers for clearance purposes, whipped up this model, slid it into Slic3r under a PETG preset I created and exported the .gcode. A few hours later Viola!
100% for first 21 layers 10% honeycomb for the remainder
Orange Makeshaper PETG 242c hotend, 75c heated bed.
Drill mounting holes
Clamp the box down.
Mark 2 hole positions 1/2" from the top edge 1" in from each side.
Drill 2 with a 3/16" drill bit.