DaVinci 1.0 Pro AiO - PLA Fanduct
inspired by ChatToBrian`s Exhaust Fan Duct, i wanted to design my own one. ;)
2x Fans 5015 50x50x15mm 12V
1x Switch KCD1-101 2Pin
1x LED 5mm
1x LED Holder Clip 5mm
1x Resistor 470 Ohm (12V/ green LED)
// Resistor 560 Ohm (12V/ red LED)
2x Screws M3 / 50mm
2x Nuts M3
Here you can find the "Cooling AddOn" for the fanduct when you us an E3D v6 hotend:
Test completed / File updates!
- Testing to load an unload Filament -> OK!
- Testing while printing -> OK!
- Testing to set/calibrate z-axis -> OK!
- Testing to switch to engraving module -> OK!