This is a single pistol holder.
Some things about the holder. The barrel rest is a little low which allowed me to place a soft rest at the bottom of it. This put it at a good height for my use. The holes you see throughout are not for looks, but was there to save on plastic.
I printed as follows:
Nozzle - .4
Filament - Inland PLA
Layer Height .3
Printer: Original Prusa i3 MK2
Print Time: ~4 hours
Edit: I found that the posts can be a little weak. So it might be good to print at 10% on the body, but at a higher % just before the posts to the top of the print.