I use the Makerbot 2x Printer http://amzn.to/2glOIXi
I Use Makerbot Printer Filament for best results http://amzn.to/2fceUUi
I use Kapton tape for the heated print bed http://amzn.to/2glJL0t
This is the FPV tilt camera gimbal that I designed a couple of years ago.
I hope everybody gets as much enjoyment out of this as I have. It has been a very nice gimbal.
It uses a HS65MG servo, and I use plumbers goop to mount the servo, and fasten it together.
Plumbers goop has been the best solution, but you have to be very careful around the servo horn, so you don't bind it.
I use Kapton tape on the print bed, and get the bet hot before I smear a light slurry mix of abs, and acetone.
I don't raft, but I use support.
Extruder Temperature is 236 °C
Platform Termperature is 110 °C