Had some unused space in our knife drawer that typically caught a few tossed in victranox knives. Wanted to see if I could make a knife block to pretty things up, hold the knives nice. Drawer is 6 5/8" wide (home deport pre-made). This is my second revision. First try lifted the knives up about 3/4" to high so the drawer wouldn't close. Made one more revision to shorten up the section for the knife blade. Now the victranox knives can slide all the way down into the block and fit well in the drawer.
might be able to make this hollow to save filament, but I think the extra weight is good in a knife block. Printed in Raspberry scented PLA, because it came with the printer, and what else am I going to do with it?
built this in tinkercad
Only the second thing I've built myself. Getting the outside dimension for the drawer was easy. Getting the spacing and angle right for the knives was trial and error. Fortunately only had to print once to figure out where adjustments were needed. Second print is now installed and in use.