This is a mount for the Mobius Mini. It is a further development of my previous mount and this new one allows you to print the mount at an angle.
See here for the first mount. That page will also give you an idea how to mount the Mobius in the mount.
Currently an angle from 0 to 30 degrees are supported. If you want to print a higher angle one you should increase the length of the front pillars.
I designed this mount so that the Mobius needs to be mounted upside down. This is to increase the cooling capability for the DSP in the camera. You can enable upside down mode in the configuration software mSetup.
Note: the openscad preview looks strange at thingiverse...
Print this mount in a flexible plastic to add some jello dampening. Personally I use Ninjaflex.
Use support to prevent sagging of the mount bed.