This is a treasure box inspired by The Legend of Zelda: The Wind Waker. The lid contains a hollow area to insert some electronics to make it interactive if you wish. Or, you can print the solid lid and use it as a jewelry box or non-interactive treasure chest.
I printed mine in different colors to show how I batched the prints together and to help show the detail. You can print the lid anchor pins in NinjaFlex so you don't have to worry about breaking them if you need to get into the cover to replace batteries.. or just print extras..
Adafruit products to make the chest interactive:
Battery holder: http://www.adafruit.com/products/783
Sound board: http://www.adafruit.com/products/2341
2.1W Amp: http://www.adafruit.com/products/1552
Mini Speaker: http://www.adafruit.com/products/1890
If you like the model, please let me know on my Facebook page: http://www.facebook.com/warmasterdook/
Please post a photo if you make one. Happy printing friends!
You need to print the below STLs X amount of times:
Bits & Bobs:
- bits0.stl - 4x
- bits1.stl - 2x
- bits2.stl - 2x
- bits3.stl - 1x
- bits4.stl - 1x
- hinge.stl - 2x
- alignment_pin.stl - 22x
- Leg0.stl - 2x
- Leg1.stl - 2x
- Lid.stl - 1x
- LidAnchorPin.stl - 2x
- LidCoverPlate.stl - 1x
*Use Lid_solid.stl if you don't need to hide any electronics. If you use Lid_solid there's no need for the anchor pin and cover plate.