Loading

MakerBot Print is our newest print-prepration software, which supports native CAD files and STL assemblies,
allows you to interact with all your printers via the Cloud, and many other exciting new features.

Download Now

pcentobie

Castle dice tower remix

by pcentobie Sep 10, 2016
Download All Files

Thing Apps Enabled

Please Login to Comment

Any chance of cutting the tower in half and including some aligning pins? As is, with a .4mm nozzle and .20 layer height, I'm looking at a 21 hour print. I'd really prefer to do that in two 10 hour prints. :)

I just did this but havent tested it. It was a clean split. If you print it let me know how it went. This should only aliign one way so it should be a good fit.

I didn't see the other post from Dec 2016 about the bottom layer being problematic. I also had difficulty but only with the tray. I cut off the bottom and stretched it vertically to keep the tabs in the same relative position as the dimples in the tower. https://www.thingiverse.com/thing:2793474

castle dice tower base remix

About how long does it take to print on a MakerBot Fifth Generation

Any chance you could do this for the verison of LennartS that has the sheilds above the door? Its a nice extra detail.

So I'm not sure if my download just messed up, but I had to use netfabb to shave .20mm off of the bottom of both files. otherwise the base had a large amount floating, and the tray was basically going to be all bridging.
http://www.thingiverse.com/thing:1956432 if anyone is running into the same issue and doesn't feel like doing the modification themselves.

Castle Dice Tower