Here is my extended version of r3z0's Tevo Tarantula case mk1. I wanted to be able to fit more components into the case. So I created an extended version that can fit my PSU as well as OcotoPi and 4 Channel Relay.
The side panels and base are split into 2 parts each so I could print them on a smaller bed. The shim that is included is used to superglue the two pieces together. The side panels also have screw offsets that accept m3x12mm screws or larger.
Update #5: (1/18/2017)
Fixed issue with RepRap Discount Controller not fitting the front top panel. The following files have been updated:
Added a larger version to fit larger power supplies. All files are prefixed with "xl_" for this version.
Adjusted side panels so there isn't a small gap when assembled.
Side panels no longer have shims for support. Screwing the two panels together is enough support to not need shims. I've also added a separate components part that is attached to the left side panel. I mainly did this so that the components part can easily be customized and doesn't require an entire reprint of the side panel.
Front Top: (2 options)
- Front Bottom:
- Left Panel (1 of 2):
- Left Panel (2 of 2):
- Left Panel w/ SD (2 of 2):
left_panel_2_w_sd.stl Use in conjunction with Front Top w/ SD (front_top_w_sd.stl)
- Component Panel:
Wiring Diagram for Components Board