I made this case as I found all the cables involved in connecting the programmer extremely messy. I bought the programmer from china at a ridiculous price (I know it is not the original, but for me its jut fine).
This is the link from where I bought it : http://www.aliexpress.com/item/Free-shipping-PICKIT3-Programmer-PIC-ICD2-PICKit-2-PICKIT-3-Programming-Adapter-Universal-Programmer-Seat/1291703648.html?spm=2114.13010608.0.112.E4MobM
I’m quite sure they are all the same size so if you get a different one it should fit anyway.
I had to do some soldering in order to make it all fit. There were only 6 wires that had to be soldered (the ICSP connector from the PicKit 3 to the relative header of the zif socket).
Now all I need to do before using it is to plug in the USB cable and I’m ready to go.
If you have any questions, please leave them in the comment section below.
Please like if you find this helpful.
You might need supports for the mini USB hole if your printer is bad at bridging. For my printer it was not needed