Needed a way to fix my Drag-Chain to my Z-axis and out to one of my motors
- 23.4mm = C
- 25mm = F
- 25.4mm = J
There is only the 1 version.
The 2 inwards-facing slits are meant for zip-ties if you need to keep cables and/or the drag-chain in place. Circle-cutout is to make room for a 10mm screw when fastening the drag-chain-
3D Source Files
Files can be looked at in 3D and dowloaded in your favorite format from Autodesk.
Various m3 and m4 nuts, screws or similar.
Using 0,4mm nozzle I printed with 3 perimeters.
Don't use higher layers than 0,25mm or you might get funny results.
The part seems very strong at 25% infill only.
It's a real bother to clean up, if you use support on the motor part... I accidentially did that, and wasn't fun to clean out!
You will need some pliers...
If you use lock-nuts you are going to need to use some sort of small pliers, as the grib afforded from the small Conduit mount isn't sufficient to hold the lock-nut in place.
Just a heads up :)