This is my first approach to build a wall mount for my aromizers and the wicking-stuff.
On top there are holes for 10 aromizers with a diameter up to 30mm.
The 10 Pins are to hang up the wire-rolls or some tools like pliers. Additionally there are seven holes for screwdrivers on each side.
All other stuff like wick or sth else can be kept in the case below.
The Support-Material seems to be a bit tricky.
The sticks for the wire-rolls shouldn't get any support, because this will cause in trouble to remove without break the pins. I've set the overhang-threshold to 1, so there is only support in the bottom-case and in the holes. Take a closer look to the preview before you print and play with support-settings if needed.